Heavy Machinery Articles

Articles>Articles Overview

1The method of flatness measurement and control1-3,7

2Technology of cooling control on the high-speed wire after rolling procedure4-7

3Features of 1# and 2# bloom casters and development of new steel grades in AnSteel8-11,14

4Full automation of oil steel pipe hardening and tempering line12-14

5Vibration isolating installation under anvil for a 50 kN electro-hydraulic free forging hammer15-18

6Intellect controller based on PROFIBUS-DP19-21

7A study on oil drill pipe end upsetting process22-25,33

8A study on 630 kN multi-point forming press for sheet metal26-28

9Factors affecting parameters of force and energy in cross wedge rolling29-33

10Analysis of erosion on the shell of electrostatic precipitator at sintering machine head part34-36,40

11The finite element analysis of the stress and deformation of the shear housings37-40

12Integrated design of mould41-43,47

13Response simulation of CVT under variable power condition of engine44-47

14Designing tube wall thickness in forming section of groove for cold rolling tube by Ks calculation method48-49

15Renovation of the vacuum system of 40 t-LFV refining furnace50-53

16New roll system of four-high finishing mill for hot-rolled narrow-strip54-55

17The research on fault diagnosis of reducer in the main drive system of the rolling mill56-58,62

18Analysis of mid-axis′ fracture in the reducers in high-speed wire mill59-62