Journal of Shenyang University of Technology Articles

Articles>Articles Overview

1Application of CMM in reverse engineering of freeform surface121-123

2Study and development of worm-drive CAD system124-126

3Principle and system designing of measuring instrument detecting bullet primer depth based on light-section method127-129

4Solution of intersect problem of two general position planes with overlapped projection line method130-132

5Optimizing design of Cr-B-W-V system high temperature-wear-resistant iron-base spray welding alloy133-136,148

6Simulation and analysis of flow-field in plasmas-gun137-139

7Fault diagnosis of power electronic circuits based on artificial neural network140-142

8Boundary contour method in analyzing permanent magnetic machine143-145

9Analysis on pith-regulated structure of MW wind turbine group146-148

10Steady-state operating performance of doubly fed variable speed constant frequency wind generation set149-152

11Optimization of electric field intensity on 550 kV insulator surface153-156

12Vibration analysis and rotor design of large line start permanent magnet synchronous motor157-159,163

13Investigation on inverse problem of circuit breaker using artificial neural networks160-163

14Sensorless control for AC permanent magnet linear servo motor using a sliding mode observer164-167

15Application of neural network in water environmental influence evaluation168-170,178

16Technology of design and realization in GPS171-173

17Application progress of neural networks in equipment fault diagnosis system174-178

18Software componentization of embedded system based on DLL179-181,187

19Research of embedded-system based on Ethernet182-184

20Application of scalping method in false points on the signal processing185-187