Internal Combustion Engine & PowerPlant Articles

Articles>Articles Overview

1Stall Investigation and Design Improvement of a Turbocharger-compressor1-4

2Design Improvement for Low-temperature Preheating Start-up System of High Power Water-cooling Engine5-7

3Study on Measurement and Analysis Method for Diesel Acceleration Signal8-11,22

4Experimental Research on Performance Effect of Oil Injector Parameters for Injection Heater12-17

5Simulation Study of Flow and Heat Transfer in Ceramic Regenerator18-22

6Development of the Blast Furnace Gas Engine Generator23-25,36

7Research of a Test Bench for Turbocharger Dynamic Balance26-28,36

8Analysis on the Particulate Filtration Characteristic of Metal Foams29-32

9Experimental Study on Diesel Engine Noise33-36

10Determine the Drilling Diameter before Threading Pipe37-40

11Emboss Phenomenon in the Piston Pin Hole and Analysis41-42

12Analysis & Treatment of Vibration of DF5 Locomotive43-46

13Research of Scuffing between Piston Ring and Cylinder Liner47-50

14Bearing Score Analysis of WD615 Engine Crankshaft51-52,56

15Analysis on the Experimental Methods and Influencing Factors of Premixed Laminar Combustion53-56